|
DESCRIPTION: AZTEC
COATINGS™ Plastic Roof Cement is a tough, all-purpose,
professional grade roof cement. Manufactured with select
asphalt, solvent and fibers, it provides a durable patching
compound. AZTEC COATINGS™ Plastic Roof Cement can be used
to patch splits, seams and cracks in bonded gravel, mineral
surfaced cap sheet and smooth surface asphalt roofs as
well as composition shingle and metal roofs. It can also
be used for repairing areas around chimneys, vent pipes,
gravel guards, down spouts, cracks in concrete and expansion
joints on roofs. Do not use on wet or damp surfaces.
PREPARATION: All surfaces
must have proper drainage and be clean, dry and free of
surface rust and any other foreign matter. For emergency
repairs use a quality roof cement or a all weather flashing
cement. DO NOT HEAT OR THIN. FOR BEST RESULTS: Apply on
clear sunny day when surface temperatures are between
50° and 120° F. In colder weather product should
be stored in heated room (65° to 80° F.) at least
24 hours prior to application. After a minimum of 45 days
cure time, apply a reflective roof coating. This will
greatly extend the life of the roof.
APPLICATION: Protective
clothing and eyewear should be used during application
of this product. Apply with a trowel or putty knife. Work
material to an even consistency over and into the area
to be repaired. Apply 1/8" to 1/4" thick, two
or three inches beyond the problem area. It is highly
recommended to reinforce repair with a strip of glass
fabric. Embed fabric into the cement and cover with a
second layer of cement. Form a feathered edge with cement
where chimneys, vent pipes and other projections meet
the roof line. Coverage rate is approximately 12 1/2 sq.
ft. per gallon when applied 1/8" thick. PRECAUTIONS:
When transporting this product, ensure that lid is tight
and pail secure and upright. Do not allow pail to tumble
as this may cause lid to loosen and leakage to occur.
Do not store at temperatures above 110° F. This manufacturer
also disclaims liability for flat surface application
where poor drainage or moisture may prevail. For exterior
use only. Do not reuse empty containers.
CLEAN-UP: Clean tools
with paint thinner or mineral spirits.
VOC/VOS - 300 g/l max. (2.5 lbs./gal.)
PETROLEUM ASPHALT C.A.S.# 8052-42-4
STODDARD SOLVENT C.A.S.# 8052-41-3
CELLULOSE FIBER C.A.S.# 9004-34-6
INORGANIC FILLER C.A.S.# 1317-65-3
CAUTION! DANGER!
HARMFUL OR FATAL IF SWALLOWED.
KEEP OUT OF THE REACH OF CHILDREN.
For exterior use only. Contains petroleum based products.
Keep away from heat, sparks and open flame. Use only with
adequate ventilation. Eye and skin irritant. Persons with
skin or respiratory sensitivity should not use product
without sufficient protection. Do not transport on passenger
seats or inside the passenger compartment of any vehicle.
Store product in the cargo area of vehicle, and secure
over protective cloths to prevent damage due to accidental
spills. Avoid contact with skin and breathing vapor. If
swallowed, do not induce vomiting. Call physician immediately.
Seal container when not in use. Do not use in drinking
water or food systems.
CALIF. PROP. 65 • CHEMICAL WARNING (CALIFORNIA HEALTH
AND SAFETY CODE #25249.5 ET SEQ) Detectable amounts of
some chemicals known to the State of California to cause
cancer, birth defects or other reproductive harm may be
found in various AZ-TEC Coatings petroleum based products
and their vapors. Read and follow label directions and
information given on Material Safety Data Sheets and use
care when handling or using all petroleum products.
|
